Part 6.75- Seatbelts revisited

In an earlier thread I showed the fabrication of a bar located behind the rear bulkhead that allowed me to raise the location of the shoulder harnesses. The next photos show the bar and its location.

http://www.uniquecobra.com/gallery/f...tbeltbrace.jpg

http://www.uniquecobra.com/gallery/f...beltbrace2.jpg

http://www.uniquecobra.com/gallery/f...beltbrace5.jpg

This is the rest of the story…
I wanted to make it easy to install and adjust the seat belts as well as make sure the anchor points were solid. I decided to fabricate brackets that could be welded to the frame. The brackets were made up useing ¼ “ flat bar with a ½ “ nut welded on. By welding the nut in place I will be able to bolt everything on with one wrench and in some cases from one side. The shoulder harness brackets are welded to the top of the cross member that the rear end bolts to as in this picture.

http://www.uniquecobra.com/gallery/f...hmentpoint.jpg

These brackets then enter into the upper part of the trunk (I will make a seal for this later) and the belts attach as shown.

http://www.uniquecobra.com/gallery/f...mentpoint3.jpg

The brackets for the inner lap belts are welded to the ends of the 2x4 tubing I installed earlier.

http://www.uniquecobra.com/gallery/f...tingpoint3.jpg

http://www.uniquecobra.com/gallery/f...tingpoint1.jpg

The inner lap belt is then attached thru the side of the tunnel.

http://www.uniquecobra.com/gallery/f...tingpoint2.jpg

The outer lap belt brackets are welded to a plate near the lock pillars. This is bolted thru to the frame later.

http://www.uniquecobra.com/gallery/f...ntingpoint.jpg

To be continued…

Nice Job, Rod.