-
Part 9 – Steering column
If you thought that by now that you had seen all of the strange things that had been done to this car you would be wrong. The next repair/cobble reversal has to do with the steering column. For some crazy reason the column had been shortened. The following picture shows the approximate position of the present column and shafts. Missing from the picture is a large Heim joint welded to a piece of steel plate that anchored the column end to the foot box top.
http://www.uniquecobra.com/gallery/f...ingcolumn1.jpg
This picture shows the length of the column (about 23” overall) and circled in red is where the cut piece had been welded back together.
http://www.uniquecobra.com/gallery/f...ingcolumn3.jpg
I have to admit I was a little nervous about trying to lengthen the column and shafts because of the serious nature of any potential weld failures, but decided to go ahead anyway.
I started by adding about a 6” length to the steering shaft. The next picture shows the un-welded pieces laying in a piece of angle iron that I clamped them onto to keep everything straight.
http://www.uniquecobra.com/gallery/f...ingcolumn5.jpg
This shot is after welding and grinding.
http://www.uniquecobra.com/gallery/f...ingcolumn6.jpg
-
Then it was time for the column housing to be lengthened. I used the angle iron method again with the newly lengthened shaft installed to help line things up.
http://www.uniquecobra.com/gallery/f...ingcolumn7.jpg
Here is the lengthened column, now about 29” long.
http://www.uniquecobra.com/gallery/f...ingcolumn4.jpg
Here it is installed in the car, the column is still shorter than original to allow room for the vibration dampener that I used. The intermediate shaft was also cut to fit.
http://www.uniquecobra.com/gallery/f...ingcolumn2.jpg
To be continued...
-
Rod,
Keep the updates coming ... they're captivating!
-
Will do Bob, there is a lot left to do.:)
-
Rod,
Looks good.
I have a ring with a set screw that goes on the column shaft and up against the housing to keep it from sliding out.
What keeps your shaft from moving out?
-
Rod, I found a picture of one in the gallery.
http://www.uniquecobra.com/gallery/f...nResistor1.jpg
Picture by Eliminator. Thanks Rick.:)
-
Just when you think you've seen it all another oddity pops up. Your work looks good.
-Geary
-
Tony, I have'nt tracked down a collar for the shaft yet, but I left enough of it sticking out to do the same as you mentioned. Good call, you guys don't miss a thing:) :)
-
Oh and by the way I had that same picture sitting on the air cleaner as I was sizing everything up, Thanks Rick
http://www.uniquecobra.com/gallery/f...ingcolumn8.jpg