Search:

Type: Posts; User: Cobranut; Keyword(s):

Search: Search took 0.00 seconds; generated 56 minute(s) ago.

  1. Thread: Gas Tank Vent

    by Cobranut
    Replies
    20
    Views
    11,714

    Roll-over valve

    I ran a larger vent line from the 1/8" NPT fitting and added a roll-over vent valve which will close off the vent if inverted. This valve is located as high as possible under the fender well.
    I...
  2. Replies
    8
    Views
    684

    Bill, I mounted an Odyssey PC1200 AGM battery...

    Bill,

    I mounted an Odyssey PC1200 AGM battery on the passenger side adjacent to the fuel filler tube.
    I built an aluminum tray and hold-down to support it.
    I prefer the weight opposite the...
  3. Replies
    12
    Views
    1,435

    I'm away from home right now so I can't be sure,...

    I'm away from home right now so I can't be sure, but I think the muffler housings are 20" long with 3.5" inlets and outlets. The inner tube is fairly small, about 3/4" or 7/8" so most of the flow...
  4. Replies
    12
    Views
    1,435

    Unique built my pipes with Lobak Spiral core...

    Unique built my pipes with Lobak Spiral core mufflers.
    They flow well but are quite loud, especially on my 12.5/1 427.
    It can be a problem at some tracks with noise limits.

    David
  5. Replies
    20
    Views
    5,624

    Rod, I hope you included the steel support...

    Rod,

    I hope you included the steel support for the brake/clutch master cylinders/pedal mount as well as the steering column which mounts to this same plate.

    David
  6. Replies
    3
    Views
    688

    Thanks guys. I got a response from Eric at...

    Thanks guys.

    I got a response from Eric at CWI. He says .020" = .5 degree.
    Both of you say .25 degree. I guess it's safe to assume it's in the .25-.50 degree range. :p

    Thanks,
    David
  7. Replies
    3
    Views
    688

    Rear alignment

    Does anyone know the shim thickness to camber angle ratio on these rears? In other words, how much shim thickness does it take to make a one degree change in camber?

    Thanks,
    David
  8. Thread: Brrrrr!!!

    by Cobranut
    Replies
    6
    Views
    1,260

    Now that's a hard-core Cobra guy. LOL

    Now that's a hard-core Cobra guy. LOL
Results 1 to 8 of 8