Search:

The 500 series should work just fine for you. Depending on the pressure plate, the horsepower rating will go up a little more. Are you running a diaphragm or Long style plate?

The 600 disc could...

....and the Thumpr cam.....

You can't take it with you... ;)

Maybe we could do some trading. We all know that I need a better website...

Hey Juan, when are you going to build another? I think you need a B2 Motorsports engine... ;-) You know the freight would at least be cheap....LOL

I think any piece of steel turning 6500 rpm is going to have enough energy to break anything that's cast aluminum. Cast aluminum is pretty brittle.

The Cup guys may run lightweight bellhousings,...

What crankshaft, rods, pistons are you using?

This is a common setup, even with internally balancing the assembly.

The issue with this scenario is that if you ever change flywheels, have to...

Why didn't you just use a 0 balance harmonic balancer?????

I don't carry the Jordan line, but if you find one that you like, chances are that I can match it in either a Hurst or a Long.

I can get whatever you need......

You can email me at brent@b2motorsportsllc.com

Or give me a call.... 502.759.1431

I'll have an HEH-BW Toploader ready to go by the middle of next week. It's a wide ratio, 1-1/16x10 input, 28 spline output. It will have new blocking rings, SKF bearings, countershaft pin, seals,...

That was going to be my next question.....how does it run with no air cleaner at all.

I do think you're onto something though, a lean condition will cause a stumble. I know on the dyno, we have...

Define sputter.... :)

He's running a solid roller.

....and the synthetic oil viscosity is too low for what I like in this engine. Keep the oil pressure up....

The dinosaur oil works just fine....you don't have anything else to put the synthetic...

Everything looks really neat and clean. They're easy to work on when there's no body....:D

Nice lookin motor.... ;)

I don't know if I would call it "successful" or not, but of course you can snag a lot more cubes with a Windsor block because the decks are so tall. Let me see if I can address some of your bullet...

I'm everywhere baby!

Paul, what engine did you decide on? Staying with the 408 or going with a 289/302?

I posted this on Club Cobra...thought it may be of interest for some of you here.

I've been contacted several times about doing a SBF that would appear period correct for the Cobra guys with...

....that I would like to advertise but definitely don't want to step on any toes.

Paul, per our conversation earlier this afternoon...

McLeod says that the floater disc is sprung and the bottom disc is marceled. So both discs are engineered to absorb some...

Sorry I missed your phone call.....call anytime....

I bet it was a pain in the butt.

I don't even like driving cars with paddle style discs, even if they have sprung hubs. I make a fool out of myself everytime and look like I've never been in a...

There's nothing at all wrong with using a lightweight small diameter clutch. What's bad about the Tilton button clutches is that they are meant to be used on a lightweight flywheel or even an...

WOOHOO! I'm alive now!