-
October 4th, 2005, 10:21 PM
#1
Part 3- Floor and Back panel
The only parts that were cut out and not discarded were the back panel, most of the tunnel and about half of the floor. I have desided to retain the ability to remove the tunnel and back panel, so rather than fiberglass them back together I made flanges out of aluminum to hold everything.
Here are two views of the backpanel-floor-tunnel
The tunnel flange..
Everything installed...
To be continued...
Rod
Roseville, Ca.
289 FIA #9152 "The Flintstone Cobra"
-
October 5th, 2005, 06:13 AM
#2
Making pretty good progress there, Rod. Have you sourced the motor and trans yet? Seems like you could be on the road in the not too distant future. Keep the pics coming!
Gary
Unique FIA 351W
-
October 5th, 2005, 08:51 PM
#3
Gary- The deal I made on the car included a brand new Ford Motorsports T5. The motor I have had sitting around for a long time, it has its own story that I'll get to later.
Rod
Roseville, Ca.
289 FIA #9152 "The Flintstone Cobra"
-
October 6th, 2005, 07:05 AM
#4
That dashboard is a trip. Looks like its for a small airplane or something.
John
Unique 289FIA #9367
351W Fuel Injected
-
October 6th, 2005, 07:20 AM
#5
Wish I had that removal arrangement when I was working in the inboard calipers! Looking good.
Phil
427 Roadster, #4279436
Southern Automotive FE
3:31 and Toploader
Roseville (N.Cal)
-
October 7th, 2005, 07:09 AM
#6
Rod--I knew it could be done, going to look good too.Will-alabama
-
October 7th, 2005, 07:10 PM
#7
Rod,
I'm smack-dab in the middle of a list of "honey-dos" after the trip to Tahoe last weekend, and haven't had a moment to clean the car up from the trip. Probably have it in the air in a couple of weeks if you need any additional measurements, etc.
Phil
427 Roadster, #4279436
Southern Automotive FE
3:31 and Toploader
Roseville (N.Cal)
-
October 8th, 2005, 09:48 AM
#8
Phil- Give me a call when you do. I plan to rebuild the rear frame section and need some exact measurements to do so. Thanks
Rod
Roseville, Ca.
289 FIA #9152 "The Flintstone Cobra"
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules