how do you adapt the stewart warner water temp fitting to an edelbrock manifold? i can't seem to find the right adapters. thx, jim
Guru
how do you adapt the stewart warner water temp fitting to an edelbrock manifold? i can't seem to find the right adapters. thx, jim
Last edited by twanita; January 23rd, 2006 at 07:37 PM.
Jim O.
Unique 427 S/C #4279479
SA 402FE,Toploader,
3.53 Posi
Senior Member
You have to get a different adapter.
It is a 3/8" pipe thread tap in the manifold and the one that came with the gauge is 1/2".
your local speedshop should have one or even a parts store that sells aftermarket gauges.
Tony
Unique 427 #4279480 Precision Engine Machine Company 427 s/o 483.47 stroker close ratio toploader 3.31 jag rear
Administrator
The port near the thermostat housing is for the heater hose connections. The temp sensor goes on the front drivers side of the manifold.
Patrick Brown
Forum Administrator
Guru
there are no locations on the drivers side that i can see. any photos of a southern automotive fe with edelbrock and single holley?
Jim O.
Unique 427 S/C #4279479
SA 402FE,Toploader,
3.53 Posi
Administrator
Sorry. I had a brain fart and was thinking small block. On the Edebrock FE intake, the port I'm thinking of is at the front center just behind the distributor.
Patrick Brown
Forum Administrator
Guru
patrick, yes, i have that one so i just have to find the adapter. thanks guys, jim o
Jim O.
Unique 427 S/C #4279479
SA 402FE,Toploader,
3.53 Posi
Posting Permissions
Reply With Quote