Does anyone know the shim thickness to camber angle ratio on these rears? In other words, how much shim thickness does it take to make a one degree change in camber?
Thanks,
David
Does anyone know the shim thickness to camber angle ratio on these rears? In other words, how much shim thickness does it take to make a one degree change in camber?
Thanks,
David
David,
According to my research, each camber shim changes camber by .25 degrees.
Bob
The shims I have had are .020 thick and like Bob posted are a quarter of degree. There are other shims out there that are thicker but I have not run into them.
Rick
427 S/C , 427 Side-oiler, 4 Speed Close Ratio Top Loader, 3:73 Gear
#4279405
Thanks guys.
I got a response from Eric at CWI. He says .020" = .5 degree.
Both of you say .25 degree. I guess it's safe to assume it's in the .25-.50 degree range.
Thanks,
David