Front Bumper Installation
Experience Needed;
I am trying to install the front bumpers and center oval bar. I cut the Finishline grommets to fit flat to the body opening. So far so good at that point. When I went install the center oval piece I encountered a real challenge. They do not begin to line up in a way that lets them fit between the two bumpers. Even with the bumper rods loosened at the frame brace, I cannot twist the two far enough to get the oval to fit between the bumpers. Is there a secret install trick ??
Thanks for the assist here.
Ric
427 SC Orange 406 FE from SA Tremec 600 #4279503