Square
"Further inspection revealed to me that the problem could only be corrected by relocating the upper rear axle mount (very firmly attached to the frame) 5/16 of an inch towards the passenger side and angled slightly down on the same side to keep the whole thing centered.
Here are the results of the changes."
The differential is bolted to the frame with 4 ea. 1/2x13 bolts, so to square the differential up you had to make some modifications to the frame/differential attachment. Just curious, how did you accomplish this since you had go approximately 5/16 "?
Rear axle plate....The way yours was done prior to your modification really didn't do a whole lot of good, the modification you made solves a lot of potential problems.
Last edited by eliminator; February 10th, 2009 at 05:45 AM.
Rick
427 S/C , 427 Side-oiler, 4 Speed Close Ratio Top Loader, 3:73 Gear
#4279405