Results 1 to 8 of 8

Thread: Exhausts leak

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Nov 2010
    Location
    Washington DC
    Posts
    4

    Exhausts leak

    Hey guys,
    I have a 351W and am having leaks in the last part of the exhaust closest in to the firewall. I changed the gasket out and got some red silicone and put the exhaust headers back on, but there is still an exhaust leak in both the last cylinders. What do I do???? Help???

    V/R

    Brad

  2. #2
    Join Date
    Feb 2003
    Location
    Birmingham, AL, USA.
    Posts
    487
    The paper style exhaust gaskets seam to burn out at the rear of engine. I looked at a copper one but the ports were rounded in the corners and not square like my heads. I ended up getting an aluminum exhaust gasket from Mr. Gasket. They fit perfect and have square cut holes. Had to re-tighten bolts a couple times but no problem.
    Bob

  3. #3
    Join Date
    Nov 2005
    Location
    paso robles Ca.
    Posts
    249
    you may also want to try going to an allen head bolt. the regular hex haed bolts are so close to the header you really can't get a wrench on them. any good steel reinforced gasket should hel,p sealant will just get cooked and blown out by the exhaust pressure.

  4. #4
    Join Date
    Sep 2003
    Location
    Roseville, CA, USA.
    Posts
    2,323
    I moved to copper gaskets and have never regretted it.
    Phil

    427 Roadster, #4279436
    FE Specialties FE
    3:31 and Toploader (wide ratio)

    Roseville (N.Cal)

  5. #5
    Join Date
    Jan 2003
    Location
    Harrisburg, PA, USA.
    Posts
    657

    Copper Gaskets

    Since the engine upgrade 12,000 miles ago I'm having exhaust gasket failures on about an annual cycle (FelPro's). I attended Bruce Larsons Drag-Fest last week end and talked to some of the drag racers there. Several recommended copper gaskets with the qualifier that they be annealed prior to installation. I understand annealing aluminum to soften it for metalworking as working it will compact and toughen the aluminum. I didn't get any definitive answers to the physics behind annealing copper gaskets except that in a dead-soft state the copper seals better.

    Any thoughts on annealing copper exhaust gaskets??

    -Geary
    Last edited by Aggressor; November 16th, 2011 at 07:24 PM.

  6. #6
    Join Date
    Jan 2003
    Location
    Harrisburg, PA, USA.
    Posts
    657
    Since the question posted above I found an ad for Annealed Ford FE Gaskets.
    I clipped it and added it below.


    Annealed Copper Exhaust Gaskets for Ford 352-427 FE
    Soft Copper Header Gaskets for Ford 390-427 FE. The port location in this gasket (for passenger vehicles) is higher relative to the bolts than p/n 34286. (see also p/n 4034, 4134, 4324) Gasket...
    List Price: $59.95
    Price too low to show. To see price, add item to cart.
    Compare At: $59.95

    Here is the web page link.

    http://www.scegaskets.com/Ford/352-4...orLanding/true

    -Geary

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •