Results 1 to 6 of 6

Thread: Turn signal replaced but still not working

  1. #1

    Turn signal replaced but still not working

    I replaced the Turn signal switch but it still not working. When I unplugged the switch the lights blinked like the switch was tuned to the hazard mode. Which I don't have. When I pluged in the new switch the lights kept blinking in the same manor. Any suggestions would be appreciated.

    Thanks,
    Mike

  2. #2
    Mike - I just solved a nagging problem which plague my switch for a long time.
    !st of all the ground wire not attached to the ground tab and 2nd was a stray chunk of solder which fortunately fell out while I examined it.

    - Geary

  3. #3
    Thanks Geary, I'll look under the dashboard.
    m

  4. #4
    Quote Originally Posted by Mike V View Post
    When I unplugged the switch the lights blinked like the switch was tuned to the hazard mode. Which I don't have.

    Mike
    Umm, are you sure you dont have a separate switch under the dash for the Hazard mode?
    Rod
    Roseville, Ca.
    289 FIA #9152 "The Flintstone Cobra"

  5. #5
    Yet again, I feel rather foolish. I do have a hazard switch under the dash. Oh I also found an extra key that was placed there by the previous owner. Everything works great now. Thanks for all the help everybody.

  6. #6
    Join Date
    Sep 2003
    Location
    Roseville, CA, USA.
    Posts
    2,436
    Mike,

    I have the exact same problem. What did you find that resolve it?

    Thanks!!!
    Phil

    427 Roadster, #4279436
    470/hp FE by FE Specialties
    3:31 and Toploader (wide ratio)

    Roseville (N.Cal)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •