-
January 17th, 2013, 01:49 PM
#1
Check you fuel filler hose
I had a scary experience pumping gas into the car. After pumping my usual 3 gallons into the car and placing the fuel nozzle back into the pump cradle, I noticed gas running out of the bottom of the car in two driver's side locations, one underneath the rear axle and the other at the rear most corner of the trunk. My initial thought was the fuel pump hose fitting had lossened from the tank. Since I couldn't get under the car at the filling station, I had planned to remove the tank and check the fuel pump fitting. When looking to see what tools would be needed to remove the tank, I noticed the filler hose had become disconnected from the tank. After removing the carpeted side panel for better access to the filler hose, I noticed the hose was fully connected to the filler but not even touching the tank filler neck. I had been pumping gas into the trunk, not the tank. Apparently, over time (15 years since my kit was built), the hose shrunk. I have since purchased a new, longer, black rubber hose from Unique. I first tried a generic black rubber fuel filler hose from a local parts store, but it kinked when bent as it didn't have the wire support inside as the one I obtained from Unique.
If any of you have an older, clear hose with the spiral wire support inside, I'd recommend you replace it with the newer black hose from Unique before your clear one shrinks.
-
January 17th, 2013, 02:47 PM
#2
battery
You can consider yourself lucky. Most of these cars I've seen have the battery in the trunk. Not a good place to have fuel fumes.
-
January 17th, 2013, 05:40 PM
#3
Agree. My battery is in the trunk. The good Lord was looking out for me.
-
March 4th, 2013, 09:01 AM
#4
Same thing
Should have posted but I had the same thing happen. When I bought my Cobra from Unique in 2005 it came with a brown, plastic connector that must have shrunk over time and pulled away from the filler cap. Was filling up when a someone next to me said "Hey - you are splashing on the ground" - pushed the Cobra away from spot and let dry. Had Weavers ship me the better rubber one.
Everyone should check but replace regardless......was scary - my friend that was driving with me for the first time was not impressed with my build quality,
Dave
-
March 19th, 2013, 06:58 PM
#5
Checked my car and it's got a metal pipe that is formed to fit between the filler and tank with a rubber connector hose at each end. I assume this was how the car was built back in 1989 but only the boss here can verify that.
Alan?
-
March 21st, 2013, 09:42 AM
#6
My car still has the original filler components after 12 years. A few years back I came across comments for sealing the fuel filler hose. I think it was either Brent or Eliminator that suggested installing the filler hose with aviation type sealant and clamps. I did have the hose to tank connection come loose once prior to sealing. The aviation sealer seems to work.
- Geary
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules