Today we did a few more little things to the engine and and it is becoming a very substantial looking assembly. Rick installed the Flywheel. Also we, mocked up and test fitted the Clutch, Pressure Plate and the newly painted Bellhousing. Notice in the photos below the Hydraulic Throwout Bearing. Also take a look at the closeups on the tool for alignment of the Clutch Disk to the Pressure Plate, see before and after photos.

We also installed a new water hose from Water Pump to Intake. Next task is for Rick to do all the measuring for a flawless installation of the Hydraulic Throwout Bearing and Transmission to the engine. The car should be painted this weekend and on to Unique for final assembly by Alan.

If things work out as planned we may have a car ready to have the engine installed by the end of June.

What do you all think of the build so far? Enjoy the photos.








New water hose.


Juan Lopez-Bonilla
Kentucky Cobra Club
2432 Crittenden Drive
Suite 201
Louisville, KY 40217
502-635-5711
juanlb@lbrllc.net

http://www.kentuckycobraclub.com