Tony sorry for the delay hear is what I have for pic's. If I get time I will take some more pic's later today of the finish look
Mike
Tony sorry for the delay hear is what I have for pic's. If I get time I will take some more pic's later today of the finish look
Mike
Thanks Mike.
I have a couple of pics. I have the demisters aswell, made it a little more fun. Hard piped it to the firewall and I am waiting on some black AN fittings.
It will be piped in the engine compartment with SS line and AN fittings.
That little heater does move some air. Two speed motor and I was able to wire a Lucas switch for it. Real clean looking. The PVC tees worked out well.
Also need some more 2" heater duct hose.The demisters are hooked up just need some more hose to pipe back to the passenger side.
Last edited by Naumoff; February 25th, 2006 at 04:23 PM.
Tony
Unique 427 #4279480 Precision Engine Machine Company 427 s/o 483.47 stroker close ratio toploader 3.31 jag rear
Got my back ordered fittings from Summit and finished my heater install last week. Backorder was for black fittings
Hoses fit nice from firewall to water pump and manifold
Made a bracket for coated clamps that attaches to valvecover bolt
Last edited by Naumoff; March 14th, 2006 at 03:55 PM.
Tony
Unique 427 #4279480 Precision Engine Machine Company 427 s/o 483.47 stroker close ratio toploader 3.31 jag rear
Had to modify one of the fittings to match the factory one that goes in the top of the manifold.
The little heater works great and puts out plenty of heat.
Had to drill out inside of fitting to fit a 1/2" O.D. tube which I JB welded into place
Last edited by Naumoff; March 14th, 2006 at 06:45 PM.
Tony
Unique 427 #4279480 Precision Engine Machine Company 427 s/o 483.47 stroker close ratio toploader 3.31 jag rear
Is the black hose you have there cloth braid or steel braided. I need to replace the steel braided line I have to my carberator and go with the black for a better look. Are the black anodized fittings any better than the red and blue fittings as far as scratching? How long of a backorder was it ?
Thanks
Mike
Mike the hoses I have are braided stainless that have been painted.
They do make a black braided hose which I would have bought but I already purchased the hoses and fittings from Unique for my oil cooler and just modified them a little. painted look is good for now.
The black fittings seem to be better against scratching as far as I can tell.
I went with black just for the look.
Tony
Unique 427 #4279480 Precision Engine Machine Company 427 s/o 483.47 stroker close ratio toploader 3.31 jag rear