Hello everyone,
Finally got the motor back in the car this week. in the process of tighting the nuts to the the mounts ,I believe i broke the bolt loose from the mounting plate. It doesn't tighten feels like it's pulling the bolt out through the rubber spacer. Plan to raise motor enough to remove mount and check it out. If broken, can i repair the mount by welding a bolt thru the mount and rubber spacer or find a new motor mount? It's a FE 428 with a three bolt pattern motor mount. Any part numbers or suggestions would be appreciated.
Engine install has gone pretty smooth, only issue was to replace orginal clutch and pressure plate due to alinment with a new aluminum flywheel. Just slow and steady progress as time permits. Take care everyone, Glenn