Clutch setup?

[pbrown]

What is everyone using for clutches? I'm getting ready to buy this stuff and am very confused. I have a 157 tooth Ford Racing billet flywheel and a Tremec TKO II tranny with a 1 1/8" x 26 input shaft. The engine is a 1994 351W truck block from Ford Racing. I need recommendations for the following:

clutch disk
pressure plate
bellhousing and trans spacer
throwout bearing
slave cylinder
clutch fork
pilot bushing/bearing

I've been thinking of using a Lakewood bellhousing and either a Centerforce or McLeod clutch.

Thanks,

Patrick

[jhaynie]

I saw a pretty cool setup for the clutch slave cylinder. Don't remember the source unfortunately . I did a search on yahoo for tremec transmissions and came up with it.
http://www.uniquecobra.com/uploaded/jhaynie/clutch_kit2_small[1].jpg

[jhaynie]

I saw a pretty cool setup for the clutch slave cylinder. Don't remember the source unfortunately . I did a search on yahoo for tremec transmissions and came up with it.
http://www.uniquecobra.com/uploaded/jhaynie/clutch_kit2_small[1].jpg

[jhaynie]

Here's a link. the picture was too big. It was the first link that came up on yahoo.
http://www.autoworks.cc/images/clutch_kit2.jpg

[jhaynie]

Here's a link. the picture was too big. It was the first link that came up on yahoo.
http://www.autoworks.cc/images/clutch_kit2.jpg

[pbrown]

That looks great. Has anyone put one of these in a Unique? Is it a good fit with the pedal assembly?

Patrick

[pbrown]

That looks great. Has anyone put one of these in a Unique? Is it a good fit with the pedal assembly?

Patrick