PDA

View Full Version : Weber question for Alan


Tony Radford
June 7th, 2003, 02:27 AM
Alan, I am strongly considering installing a quad-48IDA setup on my Windsor. With regards to the throttle linkage, it looks like the best way to work it would be to move the innermost linkage standoff to a location sightly past the intake manifold centerline and replace the existing rod with the lever with one that is longer and with the lever arm in the appropriate place at manifold center. Can I purchase the necessary rod and levers etc. from Unique? IF not, can you direct me to a place that sells such components? My plan would be to purchase the complete carb/manifold assembly from Pierce Manifolds with the linkage, fuel lines, configured carbs etc.

Thanks,

T
Poorboy
June 8th, 2003, 11:16 AM
Tony;
Determine the length you need and I'll make up the center link for you.
Poorboy
Poorboy
June 8th, 2003, 11:16 AM
Tony;
Determine the length you need and I'll make up the center link for you.
Poorboy
Tony Radford
June 8th, 2003, 06:48 PM
PB, hey thanks. Where are you located on the planet?
Tony Radford
June 8th, 2003, 06:48 PM
PB, hey thanks. Where are you located on the planet?
Poorboy
June 9th, 2003, 04:46 PM
Tony;
I'm located about 75' northwest of Unique Motorcars Gadsden assembly plant.:D;)
Poorboy
June 9th, 2003, 04:46 PM
Tony;
I'm located about 75' northwest of Unique Motorcars Gadsden assembly plant.:D;)