Rear Suspension

[406snake]

First off I would like to say that it's great to be back on here after almost a years absence. I just couldn't get onto the site for some reason but here I am now :D
Have a question on the rear suspension and I hope I don't make a fool out of myself trying to do so.
On the rear of the frame there are two hex bolts that are located under the trunk on the frame, well I found these to be lose so I just retightned them. Is there anything that I should be aware of other then just to retightned them?
I hope I made some sence.
Thanks in advance,
Charlie

[weaver]

They must not have been tightened here at the factory, don't worry they shouldn't loosen up now that they are tight.

Alan

[weaver]

They must not have been tightened here at the factory, don't worry they shouldn't loosen up now that they are tight.

Alan

[406snake]

Thanks Alan.
They were tight before as Bruce Botti and I went over the car once on delivery and when he took it back to replace the speedo.While he had it I also asked him to check everything out again. It was just this past weekend that I noticed that they were loose.
Glad to know that's all it needed since I didn't know if it effected anything else.

Thank you again,
Charlie

[406snake]

Thanks Alan.
They were tight before as Bruce Botti and I went over the car once on delivery and when he took it back to replace the speedo.While he had it I also asked him to check everything out again. It was just this past weekend that I noticed that they were loose.
Glad to know that's all it needed since I didn't know if it effected anything else.

Thank you again,
Charlie