Water Temp Fitting

[twanita]

how do you adapt the stewart warner water temp fitting to an edelbrock manifold? i can't seem to find the right adapters. thx, jim

[Naumoff]

You have to get a different adapter.
It is a 3/8" pipe thread tap in the manifold and the one that came with the gauge is 1/2".
your local speedshop should have one or even a parts store that sells aftermarket gauges.

[pbrown]

The port near the thermostat housing is for the heater hose connections. The temp sensor goes on the front drivers side of the manifold.

[twanita]

there are no locations on the drivers side that i can see. any photos of a southern automotive fe with edelbrock and single holley?

[pbrown]

Sorry. I had a brain fart and was thinking small block. On the Edebrock FE intake, the port I'm thinking of is at the front center just behind the distributor.

[twanita]

patrick, yes, i have that one so i just have to find the adapter. thanks guys, jim o