PDA

View Full Version : Rear alignment


Cobranut
May 14th, 2006, 04:41 PM
Does anyone know the shim thickness to camber angle ratio on these rears? In other words, how much shim thickness does it take to make a one degree change in camber?

Thanks,
David
bstandley1
May 14th, 2006, 09:41 PM
David,

According to my research, each camber shim changes camber by .25 degrees.

Bob
eliminator
May 15th, 2006, 05:26 AM
The shims I have had are .020 thick and like Bob posted are a quarter of degree. There are other shims out there that are thicker but I have not run into them.
Cobranut
May 15th, 2006, 09:34 AM
Thanks guys.

I got a response from Eric at CWI. He says .020" = .5 degree.
Both of you say .25 degree. I guess it's safe to assume it's in the .25-.50 degree range. :p

Thanks,
David